3046: Adafruit Feather HUZZAH - ESP8266

Summary

At the Feather HUZZAH's heart is an ESP8266 WiFi microcontroller clocked at 80 MHz and at 3.3V logic. This microcontroller contains a Tensilica chip core as well as a full WiFi stack. You can program the microcontroller using the Arduino IDE for an easy-to-run Internet of Things core. We wired up a USB-Serial chip that an upload code at a blistering 921600 baud for fast development time. It also has auto-reset so no noodling with pins and reset button pressings.

To make it easy to use for portable projects, we added a connector for any of our 3.7V Lithium polymer batteries and built in battery charging. You don't need a battery, it will run just fine straight from the micro USB connector. But, if you do have a battery, you can take it on the go, then plug in the USB to recharge. The Feather will automatically switch over to USB power when its available.

Comes fully assembled and tested, with a USB interface that lets you quickly use it with the Arduino IDE or NodeMCU Lua (it comes preprogrammed with the Lua interpreter). This version of the board has also been pre-soldered, so you can plug it right into a solderless breadboard.

Specifications

Manufacturer	Adafruit Industries LLC
Category	Open Source MCU Platforms
Eval Board Part Number	1528-1901-ND
Eval Board Supplier	Adafruit Industries LLC
IDE	Arduino IDE, with Software Add-on NodeMCU Lua interpreter
Speed	160 MHz
Bits	32 Bit
Memory, Flash/RAM	4 MB / 50 kB
Digital I/O	14 I/O, 4 PWM
Interface	I²C x1 I²S x1 SPI x1 UART x1
Analog Outputs (DACs)	0
Analog Inputs (ADCs)	1 x 10 Bit (1.0V Limit)
DMA Channels	0
Features	Battery Charger, LiPo Feather Compatible On-Board Antenna Power/Enable Pin Real Time Clock Timers
Radio	Wi-Fi 802.11 b/g/n
Interrupt Pins	0
I/O Voltage	3.3 V
Voltage In	3.7 ~ 5.5 V
Touch Sensing Pins	0
Program/Debug Interface	USB Type-Micro B
Area	1161² mm, 1.8² In
Main I.C. Base Part	ESP8266EX
Design Author	Adafruit
Date Created By Author
Date Added To Library	2018-07