Assembly Instr C49, 50 Datasheet by Amphenol RF

Assembly Instructions-C 49, C 50 Amphenol
319
Amphenol Corporation Tel: 800-627-7100 www.amphenolrf.com
Assembly
Step 1
Step 2
Step 3
Step 1 Clean cable end for .625"(16mm) min. length. Trim cable
jacket and dielectric to dimension shown. Do not nick center
conductor. Remove burrs from cable jacket and center
conductor.
Step 2 Assemble cable into connector body. Bottom cable in
connector body as shown. Solder cable to connector body
as shown.
Step 3 Solder center conductor to contact as shown. Remove
excess solder. Assemble cap and solder or lightly punch
center of cap for retention in body.
angle plug
body assembly
cap
.125
(3.2)
solder here
dimple cap
cable jacket
bottoms here
solder here
remove burrs
C50-SOLDER TO BODY TYPES FOR SEMI-RIGID CABLE WITHOUT CONTACT & INSULATOR
Step 1
Step 2
Step 3
Step 1 Clean cable end for .625"(16mm) min. length. Trim cable
jacket and dielectric to dimensions shown in table . Do not
nick center conductor. Remove burrs from cable jacket. File
blunt end of center conductor to a 90° cone.
Step 2 Assemble cable into connector body. Cable jacket and
dielectric to be flush with end of body as shown. Solder
cable to connector body. Avoid excessive heat which may
distort dielectric.
Step 3 Assemble snap ring in groove on connector body. Assemble
gasket in position as shown. Compress snap ring and
assemble coupling nut as shown.
Amphenol Connector Cable Stripping Dims., inches (mm)
Number Type RG-/U
ac
901-9201-1A SMA Plug .141 RG-402 .091(2.3) —
901-9201-1ASF SMA Plug .141 RG-402 .091(2.3) —
coupling nutgasket
snap ring
body
90°
c
a
remove burrs center conductor
coupling nut
solder here
cable jacket
flush
body
Assembly Instructions-C49, C50 Amphenol®
SMA
SOLDER TO BODY SMA ANGLE PLUGS
901-9221-1A, -1ASF for .141” S/R; 901-9221-2A, -2ASF for .085” S/R